Don’t have a dyno tuning center nearby? Are you more of a D.I.Y. (do it yourself) type? Are you constantly changing parts on your bike?
If you answer "yes" to any or all of the questions above, then the Auto Tune kit is for you. The Dynojet Auto Tune kit is an "add on" accessory that can be used with any of our Power Commander V’s. It connects to the PCV with a single cable and requires only a ground and +12 volt connection to be made to install. If your exhaust does not already have one, a "weld in" 18mm O2 sensor bung is included.
For advanced users that would like to change the Air/Fuel ratios from the baseline they are fully adjustable. Each throttle opening/rpm combination is individually adjustable, so that you can have both fuel economy, during cruise, while maintaining peak output at larger throttle openings. For most models of bikes it is also possible to adjust the Air/Fuel ratios "per gear" when used in conjunction with a properly set up Dynojet POD-300
. This gives you total control of the fueling in every gear and throttle/rpm area if required.
Note: Rottweiler Performance has just made your life easier! Choose 'YES' to the Relay Kit below before adding to the cart and make powering the Auto Tune even easier. Instructions can be seen here.
Free AFR 'Copy / Paste' chart here. (Choose your desired target AFR and just copy and paste the values right into the AFR values tab in the PCV software. 'Send' the table and done!) You must 'download' the file and have Excel on your computer.